,

2.2 Inch Bending Flex Sensor

Availability:

Out of stock


LKSEN00121

Rs 0.00

Out of stock

2.2 Inch Bending Flex Sensor

1. Specifications

  • Sensor Length: 2.2 Inches (Approximately 55.88 mm)

  • Sensor Type: Resistive Flex Sensor

  • Sensing Principle: Resistance Variation

  • Detection Method: Bending / Flexing

  • Output Type: Analog Resistance

  • Sensing Direction: Single Direction Bending

2. Sensing Specifications

  • Bent Resistance: Approximately 20–40 kΩ (typical, bend-dependent)

  • Resistance Change: Increases with bending

  • Bending Angle: Depends on sensor construction

  • Measurement Type: Relative Bending Detection

3. Electrical Specifications

  • Recommended Supply Voltage: 3.3V–5V DC

  • Output Signal: Analog voltage (using a voltage divider)

  • Output Resistance: Variable

  • Power Consumption: Low

4. Operating Conditions

  • Operating Method: Mechanical bending

  • Measurement Type: Relative bend detection

  • Calibration: Recommended for accurate bend measurement

  • Bending Direction: Follow the manufacturer’s specified bending direction

  • Mechanical Durability: Depends on bending radius and operating cycles

  • Installation: Avoid sharp folds and excessive bending

5. Applications

  • Robotic Finger Movement Detection

  • Gesture Recognition Systems

  • Wearable Electronics

  • Smart Gloves

  • Hand Motion Tracking

  • Rehabilitation Monitoring Devices

  • Flexible Control Interfaces

  • Arduino and ESP32-Based Projects

Note: Resistance values are typical estimates and vary between manufacturers. A flex sensor does not directly measure bending angle; calibration is required to convert resistance readings into approximate angles. Avoid sharp creases or bending the sensor in the wrong direction.

SKU: LKSEN00121 Categories: ,

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “2.2 Inch Bending Flex Sensor”

There are no reviews yet.