XBee USB Mini Adapter Module Board

This low-cost XBee USB Adapter Board comes in partially assembled kit form. It provides a cost-effective solution for interfacing a PC or microcontroller with any XBee or XBee Pro module. The PC connection can be used to configure the XBee Module through Digi’s X-CTU software. Works with XBee series 1 and 2 as well as Pro modules
This adapter board provides an easy interface to the XBee or XBee Pro modules by converting the 2mm pin spacing to breadboard-friendly 0.100″ spacing. The adapter board also provides a means to connect pluggable wires or solder connections and also provides mounting holes. Note: This product from Parallax uses genuine FTDI chips 10/23/14.

Features:

• Provides an easy interface to configure XBee Modules using Digi’s X-CTU software
• Converts XBee 2mm pin spacing to 0.100″ pin spacing
• 4 status indicator LEDs for Power, RSSI, Associate, and mode (sleep/ON)
• It provides easy pluggable wire or solder connections
• Includes mounting holes
• Pin-out compatible with our other XBee Adapter boards
• Partially assembled kit form for flexible configuration

Kit Contents:

• (1) XBee Adapter Board PCB
• (2) 10-pin 2mm sockets – these are soldered into the board.
• (1) 40-pin SIP header

Tools Required:

• Soldering Iron
• Solder
• Flux
• Diagonal cutters or Exacto knife

Key Specifications:

• Power requirements: 5.0V from USB or VDD pin, 3.3V generated on-board
• Communication: Serial pass-through to XBee module/USB to Host PC
• Dimensions: 1.51 x 1.00 x 0.58 in* (38.3 x 25.6 x 14.8 mm*)
  * when headers are attached
• Operating temp range: -40 to +158F (-40 to +70C)
• Works with all XBee & Pro modules!