Electronics accessories
Voltage Sensor Module DC 0-25V for Arduino Diy Kit
Availability:
In stock
LKSEN00037
රු135.00 රු150.00
In stock
CompareThis Voltage Sensor Module DC 0-25V is based on a resistive divider design principle, can reduce the voltage of the input terminal connection five times, analog input voltage up to 5V, then the input voltage of the voltage detection module can not be greater than 5V × 5 = 25V (3.3V if used system, the input voltage does not exceed 3.3Vx5 = 16.5V). Because AVR chips used in 10 AD, so the simulation resolution of this module is 0.00489V (5V / 1023), so the voltage detection module detects minimum input voltage is 0.00489V × 5 = 0.02445V.
Input voltage range: DC0-25V
Voltage detection range: DC0.02445V-25V
Voltage analog resolutions: 0.00489V
DC Input: positive terminal connected to VCC, GND negative pole
Output interface: “+” then 5 / 3.3V, “-” then GND, “s” then the AD pin
#include
int val11;
int val2;
void setup ()
{
pinMode (LED1, OUTPUT);
Serial.begin (9600);
Serial.println (“Emartee.Com”);
Serial.println (“Voltage:”);
Serial.print (“V”);
}
void loop ()
{
float temp;
val11 = analogRead (1);
temp = val11 / 4.092;
val11 = (int) temp; //
val2 = ((val11% 100) / 10);
Serial.println (val2);
delay (1000);
VISIT OUR FACEBOOK PAGE FOR MORE INFO | MORE PRODUCT IN OUR SHOP
Based on 0 reviews
Be the first to review “Voltage Sensor Module DC 0-25V for Arduino Diy Kit”
You must be logged in to post a review.
There are no reviews yet.