W1209 Digital Temperature Controller

Specifications

• Operating Voltage: 12V DC
• Output power: 20A relay
• Temperature Measurement Range: -50°C to +110°C
• Control Accuracy: 0.1°C
• Measurement Accuracy: 0.1°C
• Control Output:Relay output: 10A (max) 250V AC or 10A (max) 30V DC
• Display: 3-digit 7-segment LED display
• Sensor: NTC thermistor (10kΩ, included)
• Operating Temperature: -10°C to +60°C
• Storage Temperature: -10°C to +70°C
• Dimensions: 48mm x 40mm x 14mm

Pin Configuration

• DC+: 12V power supply positive input
• DC-: 12V power supply negative input
• IN: Sensor input
• NO: Normally Open relay contact
• COM: Common relay contact
• NC: Normally Closed relay contact

Features

• Temperature Control: It can be set to control heating or cooling based on the temperature setpoints.
• LED Display: It shows the current temperature and allows for easy adjustment of setpoints and parameters.
• Adjustable Parameters:
  • Set the desired temperature setpoint.
  • Set the hysteresis (differential) to avoid frequent switching.
  • Calibration of temperature readings.
  • Delay start for the relay to protect the controlled device.
• Relay Output: Capable of switching high current loads, suitable for various heating and cooling devices.
• Simple Operation: Easy to set up and use with three buttons: Set, Increase, and Decrease.
• Compact Size: The small form factor makes it easy to integrate into various projects and enclosures.

Usage

The W1209 temperature controller can be used in a wide range of applications, including:

• Homebrew beer fermentation temperature control
• Aquarium temperature regulation
• Greenhouse climate control
• DIY incubators
• Temperature-sensitive equipment monitoring

Setting Up the W1209

• Power Connection: Connect the 12V DC power supply to the DC+ and DC- pins.
• Sensor Connection: Connect the included NTC thermistor sensor to the IN pin.
• Relay Connection: Connect the load (e.g., a heater or cooler) to the relay contacts (NO, COM, NC) according to whether you need the normally open or normally closed configuration.
• Adjusting Settings:
  • Set Temperature: Press the “SET” button and use the “+” and “-” buttons to adjust the desired setpoint.
  • Hysteresis Setting: Long press the “SET” button to enter the parameter setting mode, use “+” and “-” to navigate to the hysteresis parameter (HC), press “SET” again, and adjust with “+” and “-“.
  • Temperature Calibration: Navigate to the calibration parameter (CA) in the parameter setting mode and adjust as needed.

Connect the power source and the load before supplying power to the controller, which displays the temperature as a measured value.

Press the SET button, the display flashes the temperature,

Press – to set the desired temperature,

After pressing SET to confirm the return,

The controller automatically performs the relay by setting off!

Indicator: Off The relay is switched off, always indicate the relay is closed.

LED: Shows LL is the sensor open, showing? HH is out of range, the thermostat will be forced to close the relay, and the display — as high-temperature protection.

1 x W1209 digital temperature controller thermostat temperature control thermostat switch plate

VISIT OUR FACEBOOK PAGE FOR MORE INFO | MORE PRODUCT IN OUR SHOP